Changes effective: October 26th, 2026
Version: 2.10.20260806.1
New Features/Enhancements
Cut Precision for Material List
A batch now supports setting Cut/Block Precision per product that has been added to a batch.
Pending Offcuts Mode
-
Available once enabled on the Operations > Location Settings page.
-
Place a check next to "Enable Pending Offcut Reservations" and click Save.
-
- New Inventory mode that allows the use of pending inventory that is planned to be produced by earlier active batches.
- New length substitution screen
Label update for Pull and Ship patterns
Cuts on pull and ship patterns will now display “Pull and Ship” instead of the print label in the tooltip.
Multi-Opti Updates
-
Length Analysis results now have an alphabetic identifier so that it is easier to track the table to the drawers below
-
New location setting to control how many lengths Length Analysis considers. Default is 2.
-
Multi-Optimization is now available from the batch list screen.
Issues Resolved
Batch Numbers occasionally get duplicated
An organization specific lock has been implemented to prevent the rare case where a batch number would be used twice when multiple users were creating a batch at the same time.
Error when changing Batch Inventory Length Preference to Stocked
The batch will no longer report an error when the Inventory Length Preference is set to "Stocked" and a product added to the batch does not have any lengths set as "Stocked".
Hundegger Exports send Batch Id instead of MaterialListProduct Id
Auto-Reconcile will now properly reconcile inventory for Hundegger saws.