Wind loads on a beam sent from BC Framer to BC Calc are not editable.

Not being able to edit the wind loads when a member is sent from BC Framer® software to BC Calc® software is expected. 

BC Framer calculates wind and snow loads per the selected building code based on the user’s settings.  Those loads include unbalanced snow loading and wind blowing from different directions and you’ll find a note for each in the Notes section of the report explaining that they were based on the building geometry.  They are not displayed in the user interface or editable because they’re system generated and require knowledge of the structure geometry and the load calculation methods from the code.  In BC Framer the member report does not show them unless you select the all loads option in the print dialog.  BC Calc doesn’t have a toggle to display the simple or all loads views yet, so all loads are shown.
The workaround is to reduce the member length to something shorter than the location of the load.  If all system loads are point loads at 8', then change the span to 7’ and click ok. (In some cases a wind load may be only inches from the left. If there are multiple spans you may have to remove all but one.) You will have invalid load location errors for any of the standard loads that were impacted, but you can ignore them.  Then change the number of spans back to the original number and length and now only the standard loads are shown. Wind loads are removed and no longer considered in the design.

Have more questions? Submit a request