Changing the preferred connector (hanger) design.

A designer may be required to change the preferred connector design if the hanger manufacturer changes. In the following example we will show the screens that are important for this change. Where SST is selected a designer may change to MiTek (previously USP).

These changes can be made on a per-job basis by editing the Job Properties > Job Settings > Connector Design:

For future job defaults, the change will be made in Manage Job Defaults:

File > Setup > Manage Job Defaults

Check the settings within the following screen(s):

For a more all-inclusive tutorial on configuring hangers in BC Framer: Hangers in BC Framer


Have more questions? Submit a request